If you send folded marketing mail that's not in an envelope, then you need to get up to speed quickly on the new tabbing regulations from the USPS that take effect on Saturday, January 5th, 2013.
These new USPS rules will require you to pay attention to a variety of factors including:
- the location of your tabs
- the size of your tabs
- the weight of your mailer
- the required number of tabs
- the thickness of the paper that you use
- the orientation of the fold
- inclusion of a staple
Raise your hand if you like more rules. Of course you don't but, the USPS has indicated that their rationale for these stricter rules is to assure that your mail piece actually makes it through the mail without being destroyed.
Let's face it, there's not much point in investing money in direct mail marketing if there's a good chance that your piece won't make it through the mail, so I have to admit that the rationale behind these changes does make sense.
Everyone sees USPS employees out delivering the mail, but what most people don't realize is the complex and expensive sorting equipment that the USPS uses to route the mail to the correct location. It's these pieces of equipment that "eats" tabbed mail that is not prepared based on these new guidelines.
New rules apply to letter-sized pieces only: Before reading further, you should know that these new regulations will only apply to letter-sized mail pieces. We're talking about pieces of mail that measure 6" x 11" or smaller when dropped into the mail-stream.
In my experience, the most common example of a self-mailer is the typical nonprofit newsletter, that gets folded down to 8.5? x 5.5? and mailed without an envelope.
Here are a few things that will disqualify your mailer right away:
- self-mailers that use only 1 tab
- using tabs at the bottom of your mailer
- using perforated tabs
- self-mailers with a gate-fold
- paper that is too thin
Letter size bulk mail should always be designed so that it folds at the bottom and tabs at the top.
How thick does my paper have to be? Standard copy paper won't cut it anymore for self-mailers. The minimum paper thickness is either 28# bond or 70# text weight paper. Self-mailers printed on paper thinner than this will not be accepted by the USPS.
If you're mailing a document that uses more than 1 sheet of paper (for instance a newsletter), then the thickness requirement only applies to the outermost sheet of paper.
How many tabs do I need? All letter-sized bulk mail pieces will require at least 2 tabs, and in some cases 3 tabs. Self-mailers, like the sample below with just one tab placed in the center will be rejected.
Does the location of
the tab matter? Yes, the location of the tab is critical! The edge of all
tabs must be within 1" of the corner. Please carefully review the samples
below. The top sample would be rejected by the USPS; however the bottom sample
would be acceptable.
In addition, to being placed along the top of the mailer,
tabs may instead be placed along the sides. In this scenario, the edge of the
tabs must still be within 1" of the corner.? The samples below shows an acceptable example of tabs used on the side; notice the tab is within 1" of the corner.
Is your self-mailer
stapled? Anything with a stitch or staple is considered a booklet.
All letter-sized booklets will require 3
tabs. Said another way, anything that includes a staple must use 3 tabs.
The location of the third tab is important because the USPS equipment grabs your mail piece from the bottom right hand side, so they want the third tab to be on the bottom right hand side. As with the other tabs, the far edge of the tab needs to be within 1" of the edge.
The photos below show two examples of?approved tabbing for booklets/stapled mailers.
How many pages can I
include in my self-mailer? If you have several pages, and opt not to staple, you are limited to how
many pages you can use based on how you fold your self-mailer:
- unstapled, bi-folded mailers are limited to six 8.5" x 11" sheets (or three 11" x 17" sheets)
- unstapled, tri-folded mailers are limited to four 8.5" x 11" sheets (or two 11" x 17" sheets)
For letter-sized, stapled self-mailers, your mail piece can weigh a maximum of 3 ounces and must be less than 0.25" thick. Remember, stitched mailers require a third tab placed 1" from the bottom right hand corner.
What about tri-folded mailers? In terms of tabs, the same requirements apply for tri-folded, self-mailers, but the requirements are even more specific. The center panel must be used for printing the address, and the final fold must fold up in the back. If you're having a hard time picturing this, just remember that self-mailers must tab from the top, and tri-folded mailers must have their address printed in the center panel.
How much does your mailer weigh? If your mail piece ways more than an ounce, you will be required to use tabs that measure at least 1.5" across, most standard tabs, and all the tabs pictured in the photos included in this article measure 1".
Other considerations: In lieu of tabs, glue dots may be used. The glue dots need to be a minimum of 3/8" thick and need to follow the same guidelines as tabs in terms of distance from the edge, and number of required glue dots.
Plan ahead to avoid issues with your next bulk mailing. If you're unsure, it's always a good idea to stop by your local Bulk Mail Unit with a sample. Ask for feedback on your sample piece, before you design and print all pieces.
What should I do if I already printed my mail piece and I'm stuck? If your mail piece is already printed and the paper is too thin, or it's designed to fold incorrectly, you can always just mail it in an envelope.
If your mail piece is printed on a standard 8.5" x 11" sheet, it will fit nicely in a standard 6" x 9" envelope and still qualify to mail at the letter rate. In the worst case scenario, if your addresses are already printed too, you may be able to use a 6" x 9" giant window envelope like the sample pictured below.
Of course, if you rely on your mailings to generate new
business or collect donations from your supporters, and you want to avoid the
complexities of mailing, we invite you to please contact us to see how we can
help get your next mailer designed, printed, addressed and mailed.
In case it's not apparent from this short article, we sweat the small stuff to make sure that our clients mailing is designed, printed and prepared in a manner to meet all postal guidelines while saving the maximum amount on postage.
Of course please also feel free to contact us with your questions or share your comments below.
Like what you're reading?? Have you signed up for our weekly enews yet or are you following our blog's rss feed?
fat tuesday obama sweet home chicago accenture match play george washington carver king cake mardi gras fun.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.